MUSTANG P-51D
This is our 3D printed version of a legend, the North American P-51D. The main goal of this project since the beginning was to be able to offer a Mustang with a 3D printed, functional and strong retractable landing gear concept. This way our clients will not need to buy the expensive commercial aluminium retracts. The challenge was huge, we worked hard and tested several concepts until we finally found a good solution.
In addition to this the design is optimized to be printed with LW-PLA: The numbers of travels are minimum allowing you to improve surface quality, reduce stringing and reduce the risk of clogging your nozzle
Includes:
-STL files
-Scheme design
-G-codes for PLA and LW-PLA
€37
Features:
-3D printed retracts
-Printed without retractions
 |  |  |  |  |
|---|---|---|---|---|
 |  |  |  |  |
 |  |
SPECIFICATIONS
LW-PLA PLA
PRINTED WEIGHT 440g 800g
TAKE OFF WEIGHT 850g 1300g
STALL SPEED 26km/h 32km/h
MIN WING LOADING 40g/dm² 61g/dm²
WING SPAN 1100mm (43")
WING SURFACE 21dm²
WING ASPECT RATIO 5,2
LENGTH 900mm
SHOPPING LIST
ALL THE COMPONENTS THAT YOU HAVE TO BUY TO FLY THE AIRPLANE
3D PRINTER
MIN PRINTING VOLUME - 210x210X200 (X,Y,Z)
NOZZLE DIAMETER - 0,4 mm
Recommended
FILAMENT
QUANTITY - ≈440g (LW-PLA) or ≈800g (PLA)
Recommended
ECLIPSON STANDARD POWER PACK
SERVOS NEEDED - x6
Recommended
BATTERY
VOLTAGE - 11,1V (3S)
CAPACITY - 1500 mAh
DISCHARGE - >20C
Recommended
BAT2
RADIO CONTROL SYSTEM
MIN CHANNELS - 7CH
Recommended
OTHER PARTS
-PUSH RODS - D1,2mm (min length 600mm) 5units
-STEEL ROD - D3mm (Length 130mm) 2units
-CF TUBE - D10mm (Length 400mm) 1unit
-STOP COLLARS D3,1mm 2units
-STOP COLLARS D2,1mm 1unit
-BOLT - M3X15mm (with nuts and washers) 4units
-BOLT - M3X25mm (with nuts and washers) 2units
-SCREW - M2X8mm (aprox) 42units
-GLUE - cyanoacrylate
-PUSH RODS CONNECTORS 6units
-RUBBER BAND- L50mm (aprox.)
Recommended
