MODEL A

Eclipson model A is just a functional 3D printed RC plane extremely easy to print, assemble and fly. So if you are a beginner with 3D printed planes this is your model!. The plane has been designed from scratch to be 3D printed and to be an RC plane, meaning that his outer shape has been optimised for those purposes and that is the key factor that explains why this model flies  incredibly  well without any extra drag or extra weight typical from scale models, but also explains why it is so easy to assemble since it uses very little parts allowing you to rebuild the plane quite fast and for a really low price: Just 12€ if printed with LW-PLA or 6€ if printed with cheap PLA. So do not be afraid of crashing this model, the electronics will survive and can be reused not only in the next model A that you print but also in any of our designs since we have standardized all the electronic components to reduce even more the price of your RC plane.

Includes:
-STL files

-Scheme design
-G-codes for PLA and LW-PLA
For free:

-Cura profiles

€13.5

Features:

-Trainer
-Easy to assemble

-Vase mode design

-Removable wing and LG

-Full flaperon design

Eclipson Model A
RC aircraft trainer
Designed to be 3D printed
Strong landing gear design
Printable rc plane
Aerodynamic analisys
Vase mode design

SPECIFICATIONS

                                    LW-PLA    PLA
PRINTED WEIGHT              220gr   390gr

TAKE OF WEIGHT*             490gr   730gr
STALL SPEED                    24kmh  29kmh
WING LOADING                              30g/dm²    45gr/dm² 

WING SPAN               1000mm (39")

WING SURFACE          16dm2

WING ASPECT RATIO   6,6
LENGTH                     760mm

* Weight including landing gear

ARRANGEMENT DRAWING AND PRINTING PARAMETERS

SHOPPING LIST

ALL THE COMPONENTS THAT YOU HAVE TO BUY TO FLY THE AIRPLANE

3D PRINTER

MIN PRINTING VOLUME - 150x150X190 (X,Y,Z)
NOZZLE DIAMETER - 0,4 mm

Recommended

FILAMENT

QUANTITY - 220gr (LW-PLA) or 390gr (PLA or PETG)


Recommended

ECLIPSON STANDARD POWER PACK

SERVOS NEEDED - x4

Recommended

BATTERY

VOLTAGE - 7,4V (2S) or 11,1V (3S)

CAPACITY - 500 mAh to 1500 mAh

DISCHARGE - >20C 

Recommended

PLA version: BAT2
LW-PLA version: BAT1

RADIO CONTROL SYSTEM

MIN CHANNELS - 6CH

Proposed - flysky fs-i6x (with i6X-iA6B receiver)

OTHER PARTS

-PUSH RODS - D1,2mm (min length 450mm)  4units
-STEEL ROD - D2
mm (Length 180mm) 4units
-
STOP COLLARS D2,1mm  2units
-BOLT - M3X15mm (with nuts and washers)  4units

-SCREW - M2X8mm (aprox) 26units
-RUBBER BAND  units

-VELCRO

-WIRE - 0,5 mm

-GLUE - cyanoacrylate + accelerator
-
PUSH RODS CONNECTORS  4units
-SPONGE WHEEL 2units (Alternatively you can print it)
    Diameter 40 mm

    Wide 10,5 mm

    Inner hole D2mm

Eclipson 3d printed aircraft
  • Eclipson youtube
  • 3d printed plane instagram
  • Facebook eclipson
© 2020 Eclipson Airplanes. All Rights Reserved.
Madrid, Spain
Terms & condition / Privacy policy / Refund policy / Fulfillment policy
0

MY CART