MODEL V2

This is the version 2 of our successful Model V. Drag and weight are the two main enemies of any flying machine, reducing those two forces to the minimum was one of the main goals of this project since the conceptual phase. The drag was reduced thanks to its streamlined shapes, clean design, V tail, high aspect ratio or winglets. The wing has a great balance between safety (docile stall characteristic) efficiency (high lift to drag ratio) maneuverability (high roll rate) and strength (Reinforced with carbon fiber tubes).
The size of this motorglider is perfect to be manufactured with a 3D printer because it is large enough to achieve a docile flight and small enough to be manufactured quickly, easily and cheaply.

Includes:
-STL files
-Decals (2 Schemes)

-G-codes for PLA and LW-PLA

€27

€20,25

Features:
-Motor glider

-Low wing trainer (LW-PLA)

-2 alternatives landing gears + keel

-Printed without retractions

Streamlined design
Model V lightest 3d printed plane
Aerodynamic wheel fairing
Printable rc plane
V tail of the model V
Horn cover
Stronger landing gear
Canopy with magnet
Stronger motor mount
2 alternatives schemes

SPECIFICATIONS

                                    LW-PLA    PLA
STRUCTURE WEIGHT        200gr    430gr

TAKE OFF WEIGHT            500gr    770gr
STALL SPEED                   24kmh  29kmh
WING LOADING                              31g/dm²    48/gr/dm² 

WING SPAN               1,370mm

WING SURFACE          15,9dm2

WING ASPECT RATIO   11,8
WING AIRFOIL            NACA4412
LENGTH                     765mm

ARRANGEMENT DRAWING AND PRINTING PARAMETERS

Printing_parameters_.jpg

ASSEMBLY GUIDE

SHOPPING LIST

ALL THE COMPONENTS THAT YOU HAVE TO BUY TO FLY THE AIRPLANE

3D PRINTER

MIN PRINTING VOLUME - 200x200X190 (X,Y,Z)
NOZZLE DIAMETER - 0,4 mm

Recommended

FILAMENT

QUANTITY - 200gr (LW-PLA) 430gr (PLA or PETG)


Recommended

colorfabb.JPG

ECLIPSON STANDARD POWER PACK

SERVOS NEEDED - x4

Recommended

 

Captura.PNG

BATTERY

VOLTAGE - 11,1V (3S) or 7,4V (2S)

CAPACITY - 500 mAh to 2000 mAh

DISCHARGE - >20C 

Recommended

PLA version: BAT2

LW-PLA version: BAT1

bat.jpg

RADIO CONTROL SYSTEM

MIN CHANNELS - 5CH

Recommended

Captura.JPG

OTHER PARTS
-PUSH RODS - D1,2mm (min length 500mm)  5units
-BOLT - M3X25mm (with nuts and washers)  3units
-
BOLT - M3X15mm (with nuts and washers)  4units
-SCREW - M2X8mm 16units
-VELCRO
-GLUE - cyanoacrylate + accelerator
-SERVO LEAD EXTENSION (min 200mm) 2 units
-SPONGE WHEEL  2units (Alternatively you can print it)

    Diameter 40mm
    Wide 10,5mm
    Hole 2mm
-CARBON FIBER TUBE - D6x4mm (length 500mm) 1units
-CARBON FIBER TUBE - D4x3mm (length 250mm) 2units
-CARBON FIBER ROD
- D2mm (Length 500mm) 2units           
-MAGNETS - 10x5x3mm 2units (alternatevely you can use 0.5 wire)
-STOP COLLARS D2,1mm  6units

-PUSH RODS CONNECTORS  5units

rods.JPG
Eclipson 3d printed aircraft