MODEL Y
Eclipson Model Y is a radio control airplane specifically designed to be printed. Thanks to his high wing configuration the airplane is very stable. His elliptical wing reduces wing tip vortex, therefore reduces induce drag and increases flying time. It has been designed with flaperons, the same aerodynamic surface is used as flaps and ailerons. We provide two different main landing gears solutions, one 3D printed and other mixed with steel rods and sponge wheels, the first is cheaper and the second stronger, use the one that you prefer. Nose landing gear is steerable and with suspension totally 3D printed, you will only need a rubber band, also free FPV kit for this plane is available.
€16
Features:
-Steerable nose gear
-Nose suspension
-Easy to build
-Flaperons
![]() | ![]() | ![]() | ![]() | ![]() |
---|---|---|---|---|
![]() | ![]() | ![]() | ![]() | ![]() |
![]() | ![]() |
SPECIFICATIONS



LW-PLA PLA
STRUCTURE WEIGHT 240gr 400gr
TAKE OF WEIGHT 480gr 740gr
STALL SPEED 25kmh 30kmh
MAX GLIDE RATIO 15 16
WING LOADING 36g/dm² 56/gr/dm²
WING SPAN 1m
WING SURFACE 13,1dm2
WING ASPECT RATIO 7,2
WING AIRFOIL NACA2412
ARRANGEMENT DRAWING AND PRINTING PARAMETERS

ASSEMBLY GUIDE AND REVIEW
SHOPPING LIST
ALL THE COMPONENTS THAT YOU HAVE TO BUY TO FLY THE AIRPLANE



BATTERY
VOLTAGE - 11,1V (3S) or 7,4V (2S)
CAPACITY - 500 mAh to 2000 mAh
DISCHARGE - >20C
​
Recommended
PLA version: BAT2
LW-PLA version: BAT1


OTHER PARTS
-PUSH RODS - D1,2mm (min length 450mm) 3units
-TAPE
-BOLT - M3X30mm (with nuts and washers) 2units
-SCREW - M2X8mm (aprox) 14units
-VELCRO
-RUBBER BAND
-WIRE - 0,5 mm
-GLUE - cyanoacrylate + accelerator








OPTIONAL PARTS
(The following parts are not necessary, but they are recommended)
-SPONGE WHEEL 3units
Diameter 40mm
Wide 10,5mm
Hole 2mm
-STEEL RODS D2mm (flexible, min length 150mm) 2units
-STOP COLLARS D2,1mm 6units
-PUSH RODS CONNECTORS 5units
​



