top of page
THE GRAYWING
EGW-80 EDF
This is the Electric Ducted Fan version of our successful Eclipson EGW-80. Thanks to the use of the EDF motor we could add a very useful landing gear with full suspension, the concept is totally 3d printed and well tested, although this LG is just optional, we also provide you the keel to hand launch the model. The plane can be printed with PLA/ PETG but you will get much better performance and a higher thrust to weight ratio if printed with LW-PLA.
Includes:
-STL files
-G-codes for PLA and LW-PLA
For free:
Features:
-Very low drag design
-FPV camera ready
-Replaceble LG
-Full suspension
€27
SPECIFICATIONS
LW-PLA PLA
PRINTED WEIGHT 230g 420g
TAKE OFF WEIGHT 490g 750g
STALL SPEED 27km/h 35km/h
WING LOADING 37g/dm² 57g/dm²
WING SPAN 800mm (31")
WING SURFACE 13dm2
WING ASPECT RATIO 3,5
WING AIRFOIL NACA 65-209 mod
LENGTH 750mm
Note: LW-PLA version is highly recommendable for this model to get a more adequate thrust to weight ratio.
SHOPPING LIST
ALL THE COMPONENTS THAT YOU HAVE TO BUY TO FLY THE AIRPLANE
FILAMENT
QUANTITY - 230g (LW-PLA) or 420g (PLA or PETG)
Recommended
BATTERY
VOLTAGE - 14,8V (4S)
CAPACITY - 1300 mAh to 2200 mAh
DISCHARGE - >20C (the lower the more efficient)
WEIGHT - 220 g for PLA
150 g for LW-PLA
(Recommended to set the C.G.)
Proposed -
PLA- BAT3
LW-PLA- Turnigy Nano-Tech Plus 1300mAh 4S
OTHER PARTS
-PUSH RODS - D1,2mm (min length 50mm) 2units
-BOLT - M3X15mm (with nuts and washers) 4units
-SCREW - M2X8mm (aprox) 18units
-VELCRO
-WIRE - 0,5 mm
-GLUE - cyanoacrylate + accelerator
-PUSH RODS CONNECTORS 2units
-SERVO LEAD EXTENSION (min 400mm) 2 units
-STEEL ROD - D2mm (Length 60mm) 1units
-STOP COLLARS D2,1mm 6units
Recommended
bottom of page