THE BLACKWING SPORT
EBW-140

This is the little brother of our great Blackwing, this version is smaller, more agile and faster than the original one therefore it is more adequate if you are planning to make an aggressive flight. In case you wanna fly FPV the model has been designed to work with the camera Eachine TX02 or similar that can be directly powered by the receiver, there is no need of installing a flight controller or VTX allowing you to save weight, money and assembly time.

Includes:
-STL files

-G-codes for PLA and LW-PLA
For free:

-Cura profiles

€17

Features:

-FPV camera ready
-Wire skids for landing in asphalt

-Launch handle

-Printed without retractions

Blackwing brothers
Blackwing
Blackwing
3D printed flying wing

SPECIFICATIONS

                                    LW-PLA    PLA
STRUCTURE WEIGHT        250gr    450gr

TAKE OF WEIGHT             480gr    700gr
STALL SPEED                   24kmh  30kmh
WING LOADING                              25g/dm²    37/gr/dm² 

WING SPAN               1400mm (55")

WING SURFACE          19dm2

WING ASPECT RATIO   9

ARRANGEMENT DRAWING AND PRINTING PARAMETERS

ALTHOUGH THE ASSEMBLY VIDEO BELONGS TO ANOTHER MODEL THE CONCEPT OF THE ASSEMBLY PROCESS IS THE SAME

SHOPPING LIST

ALL THE COMPONENTS THAT YOU HAVE TO BUY TO FLY THE AIRPLANE

3D PRINTER

MIN PRINTING VOLUME - 180x180X195 (X,Y,Z)
NOZZLE DIAMETER - 0,4 mm

Recommended

FILAMENT

QUANTITY - 250gr (LW-PLA) or 450gr (PLA or PETG)

Recommended

ECLIPSON STANDARD POWER PACK

SERVOS NEEDED - x2

Recommended

BATTERY

VOLTAGE - 11,1V (3S)

CAPACITY - 1000 mAh to 1500 mAh

DISCHARGE - >20C 

Recommended

BAT2

RADIO CONTROL SYSTEM

MIN CHANNELS - 3CH

Proposed - flysky fs-i6x (with i6X-iA6B receiver)

FPV SYSTEM

Recommended

OTHER PARTS

-PUSH RODS - D1,2mm (min length 50mm)  2units

-BOLT - M3X15mm (with nuts and washers)  4units

-SCREW - M2X8mm (aprox)  30units

-VELCRO
-CARBON FIBER TUBE - D6x4mm (length 300mm) 1units

(Not necessary for PLA version)
-CARBON FIBER TUBE - D4x3mm (length 500mm) 2units
(Not necessary for PLA version)

-GLUE - cyanoacrylate + accelerator
-PUSH RODS CONNECTORS  2units
-WIRE - 0,5 mm
-SERVO LEAD EXTENSION
 (min 400mm) 2 units
-TAPE

Eclipson 3d printed aircraft
  • Eclipson youtube
  • 3d printed plane instagram
  • Facebook eclipson
© 2021 Eclipson Airplanes. All Rights Reserved.
Madrid, Spain
Terms & condition / Privacy policy / Refund policy / Fulfillment policy
0

MY CART